DIN 127 Spring Lock Washer — Square Section
A split helical spring washer intended to resist loosening. Worth knowing that independent testing has repeatedly found its locking effect is marginal once the joint is properly preloaded — for safety critical joints use a prevailing torque nut instead.
Where it is used
DIN 127 is the square section spring lock washer, which resists loosening through the spring reaction as it is flattened. It is used for bolt locking on general machinery where cost and simple installation matter.
How to choose it
The locking value of spring washers has long been disputed, and modern work suggests it is limited in a properly preloaded joint because the available elastic travel once flattened is small. It still does something where preload is marginal or vibration is slight. For joints that matter, use a DIN 985 lock nut or thread adhesive instead.
Dimensions11 sizes · millimetres
| Nominal size | Inside diameter d1 (mm) | Section s (mm) | Free height h (mm) |
|---|---|---|---|
| M3 | 3.1 | 0.8 | 1.6 |
| M4 | 4.1 | 0.9 | 1.8 |
| M5 | 5.1 | 1.2 | 2.4 |
| M6 | 6.1 | 1.6 | 3.2 |
| M8 | 8.1 | 2 | 4 |
| M10 | 10.2 | 2.2 | 4.4 |
| M12 | 12.2 | 2.5 | 5 |
| M14 | 14.2 | 3 | 6 |
| M16 | 16.2 | 3.5 | 7 |
| M20 | 20.2 | 4 | 8 |
| M24 | 24.5 | 5 | 10 |
Nominal dimensions in millimetres as published in DIN 127. Tolerances, material requirements and marking are defined separately by the issuing body.
Available sizeslinked to individual specification pages
Fitting and interchange notes
On hard clamped parts a spring washer will score the surface, so avoid it on visible or precision components. There is no strict rule on which way the split faces, but avoid leaving the gap sitting exactly on the edge of the clamped part.