ISO 7089 Flat Washer — Normal Series, 200 HV
The general purpose flat washer. It protects the clamped surface, bridges oversized holes and spreads load under the head or nut.
Where it is used
ISO 7089 is the normal series plain washer. Its purpose is to spread the load under a bolt head or nut, protect the clamped surface, and bridge the clearance between hole and bolt. This is the highest-volume washer type there is.
How to choose it
Hardness class is 200 HV, above the 140 HV of DIN 125, so it resists being crushed in high-preload joints. 200 HV normally means low carbon steel with surface hardening, or stainless strengthened by cold work.
Dimensions13 sizes · millimetres
| Nominal size | Inside diameter d1 (mm) | Outside diameter d2 (mm) | Thickness h (mm) |
|---|---|---|---|
| M3 | 3.2 | 7 | 0.5 |
| M4 | 4.3 | 9 | 0.8 |
| M5 | 5.3 | 10 | 1 |
| M6 | 6.4 | 12 | 1.6 |
| M8 | 8.4 | 16 | 1.6 |
| M10 | 10.5 | 20 | 2 |
| M12 | 13 | 24 | 2.5 |
| M14 | 15 | 28 | 2.5 |
| M16 | 17 | 30 | 3 |
| M18 | 19 | 34 | 3 |
| M20 | 21 | 37 | 3 |
| M22 | 23 | 39 | 3 |
| M24 | 25 | 44 | 4 |
Nominal dimensions in millimetres as published in ISO 7089. Tolerances, material requirements and marking are defined separately by the issuing body.
Available sizeslinked to individual specification pages
Fitting and interchange notes
Dimensionally interchangeable with DIN 125 A, but the hardness class differs — and that is the substantive difference between them. If a drawing specifies both dimensions and hardness, verify the hardness of what arrives, because the two look identical. Hard washers with high-strength bolts are a sensible pairing; a soft washer under a class 12.9 bolt will collapse before the bolt reaches preload.