DINboltsHexagon head

DIN 933 Hexagon Head Screw / Bolt — Full Thread

A hexagon head fastener threaded all the way to the head. Glyph marking on the head identifies the property class, normally 8.8, 10.9 or A2-70.

Dimensioned drawing — DIN 933 M12 × 70k 7.5L 70⌀20.03⌀12
DIN 933 M12 × 70 — Hexagon headNominal dimensions in mm · Not to scale

Where it is used

DIN 933 is the fully threaded hexagon head bolt, with thread running all the way to the head. It is used where the nut position has to be adjustable along the length, or where a range of clamped thicknesses must be covered. Full thread lets one part number serve several grip lengths, which simplifies stocking.

How to choose it

Common classes are 8.8, 10.9 and 12.9, with the class and manufacturer marked on the head. The threaded cross-section is smaller than the plain shank of the same size, so load capacity in shear is lower than a partially threaded bolt — a point that is often overlooked. Where the joint is primarily in shear, specify a partially threaded type such as DIN 931 instead.

Dimensions12 sizes · millimetres

Thread dPitch P (mm)Width across flats s (mm)Width across corners e (mm)Head height k (mm)
M40.777.662.8
M50.888.793.5
M611011.054
M81.251314.385.3
M101.51617.776.4
M121.751820.037.5
M1422123.358.8
M1622426.7510
M182.52730.1411.5
M202.53033.5312.5
M222.53437.7214
M2433639.9815

Nominal dimensions in millimetres as published in DIN 933. Tolerances, material requirements and marking are defined separately by the issuing body.

Available sizeslinked to individual specification pages

Thread referencesused by the sizes above

Fitting and interchange notes

Dimensionally interchangeable with ISO 4017. Width across flats steps with nominal diameter: 16 mm at M10, 18 mm at M12, 24 mm at M16, so match the wrench accordingly. The friction coefficient of a plated bolt varies with coating and lubrication, which changes the preload actually achieved — use torque-plus-angle control on critical joints.