ISO 4014 Hexagon Head Bolt — Partial Thread, Product Grade A/B
ISO version of the partial thread hexagon head bolt. The standard thread length is defined by nominal length bands, so long bolts have a proportionally longer plain shank.
Where it is used
ISO 4014 is the ISO designation for the partially threaded hexagon head bolt, used in steelwork, bridges and equipment foundations where the joint is dominated by shear and location.
How to choose it
Product grades A and B apply here too, with grade A for threads up to M24. Thread length steps with nominal length per the ISO 4014 table and differs slightly from DIN 931, so check the actual figure when buying near a length boundary.
Dimensions12 sizes · millimetres
| Thread d | Pitch P (mm) | Width across flats s (mm) | Width across corners e (mm) | Head height k (mm) | Thread length b (L ≤ 125 mm) (mm) |
|---|---|---|---|---|---|
| M4 | 0.7 | 7 | 7.66 | 2.8 | 14 |
| M5 | 0.8 | 8 | 8.79 | 3.5 | 16 |
| M6 | 1 | 10 | 11.05 | 4 | 18 |
| M8 | 1.25 | 13 | 14.38 | 5.3 | 22 |
| M10 | 1.5 | 16 | 17.77 | 6.4 | 26 |
| M12 | 1.75 | 18 | 20.03 | 7.5 | 30 |
| M14 | 2 | 21 | 23.35 | 8.8 | 34 |
| M16 | 2 | 24 | 26.75 | 10 | 38 |
| M18 | 2.5 | 27 | 30.14 | 11.5 | 42 |
| M20 | 2.5 | 30 | 33.53 | 12.5 | 46 |
| M22 | 2.5 | 34 | 37.72 | 14 | 50 |
| M24 | 3 | 36 | 39.98 | 15 | 54 |
Nominal dimensions in millimetres as published in ISO 4014. Tolerances, material requirements and marking are defined separately by the issuing body.
Available sizeslinked to individual specification pages
Thread referencesused by the sizes above
Fitting and interchange notes
Interchangeable with DIN 931, and again short sizes convert to full thread. In shear joints the plain shank must span at least the full thickness of the clamped parts; if thread crosses the shear plane the capacity drops sharply. This is the easiest design error to make and the hardest to spot in service.