DINanchor-bolts

DIN 529 B Anchor Bolt, Form B

Form B of DIN 529: the same thread, thread length and head width as form A, in a shank the standard does not describe. That is not a gap in this page — DIN 529 states that the shape of the shank is left to the manufacturer, so what separates the forms is the embedded end, and the table only carries the columns for it. Form B has no c column at all, and its g column is blank for M8, M10 and M12; both facts are reproduced here as blanks rather than filled in from another form.

Dimensioned drawing — DIN 529 B M30head not drawn — see a and c in the table⌀d 30b 75
DIN 529 B M30 — Anchor boltNominal dimensions in mm · Not to scale

Where it is used

Form B of DIN 529 uses the same thread, thread length and head width as form A and differs in the embedded end. The standard does not describe that end — it states that the shank shape is left to the manufacturer — so what the table can say about form B is narrower than what a catalogue typically claims for it. On the pages that follow, the columns printed are the thread, its length, a and g. There is no c column for this form anywhere in the 2010 edition, and g is blank for M8, M10 and M12; both absences are reproduced as they are rather than filled from a neighbouring form, because a number borrowed from form A would look exactly like a number from form B.

How to choose it

Where a drawing names form B, the dimensions that decide whether the bolt fits are the thread, the thread length b and the width a; c is not tabulated and cannot be read off this standard. Thread, length and nut selection follow form A: the thread has to take the nut and washer, and the length is set by plate thickness plus embedment. Because the shank is open, two suppliers can deliver form B bolts that differ behind the head while both match this table — if that matters to the joint, the embedded end has to be specified on a drawing rather than by the standard number alone.

Dimensions12 sizes · millimetres

Thread dPitch P (mm)Thread length b (mm)a (mm)g (mm)
M81.252024—
M101.52530—
M121.753036—
M162404845
M202.5506055
M243607570
M303.5759590
M36490115110
M424.5105135125
M485120155140
M565.5140180165
M646160200185

Nominal dimensions in millimetres as published in DIN 529 B. Tolerances, material requirements and marking are defined separately by the issuing body.

Available sizeslinked to individual specification pages

Thread referencesused by the sizes above

Fitting and interchange notes

Form B has no c value in the 2010 edition, and its g column starts at M16: the three cells for M8, M10 and M12 are printed as dashes. This page keeps the blanks and shows them as blanks, which is why those sizes carry three tabulated columns instead of four. The rest of the standard's qualifications apply unchanged and are set out on the form A page: the shank shape is left to the manufacturer, no pull-out resistance is stated, there is no mass table, and the a and c columns are printed as letters without a legend in any reproduction this site can check. The commercial length series runs 80 to 3200 mm; no dimension in the table changes with length, so no per-length pages are generated. The table reaches M72x6, which has no page here because this database has no ISO 261 coarse record above M64.