DINanchor-bolts

DIN 529 E Anchor Bolt, Form E

Form E has no g column in the 2010 table, and its a and c columns stop at M48, so this page runs to M48 while forms A and B run to M64. Two of its c values are larger than the c max printed in the same edition — M24 and M42 — and both are recorded on this page rather than smoothed over: a reader comparing the two tables of one standard deserves to see the two cells where they disagree.

Dimensioned drawing — DIN 529 E M24head not drawn — see a and c in the table⌀d 24b 60
DIN 529 E M24 — Anchor boltNominal dimensions in mm · Not to scale

Where it is used

Form E shares its head width with form C and has no g column at all in the 2010 edition. It is the shortest run of the five: a and c are printed from M8 to M48 only, so this page stops at M48 while forms A and B continue to M64. As with every form of DIN 529, the bolt holds by its buried head and the nut on the free thread, and the standard states no pull-out resistance because the joint's strength belongs to the masonry and to the embedment depth rather than to the bolt.

How to choose it

Use the a and c columns to check that the head fits the pocket, exactly as for form C, whose a row it shares. There is nothing to read in a g column for this form — not because the value is missing from this page, but because the standard does not print that column for E. Above M48 the standard tabulates nothing for this form, so a drawing that calls for form E at M56 or M64 cannot be checked against DIN 529 and has to be specified dimensionally.

Dimensions10 sizes · millimetres

Thread dPitch P (mm)Thread length b (mm)a (mm)c (mm)
M81.25201645
M101.5252055
M121.75302470
M162403290
M202.55040100
M2436048135
M303.57560150
M3649072180
M424.510585260
M48512098260

Nominal dimensions in millimetres as published in DIN 529 E. Tolerances, material requirements and marking are defined separately by the issuing body.

Available sizeslinked to individual specification pages

Thread referencesused by the sizes above

Fitting and interchange notes

Two of the c values printed for form E are larger than the c max printed in the first table of the same 2010 edition: 135 against a limit of 130 at M24, and 260 against 230 at M42. Every other cell in the family sits inside the limits. Both discrepancies are left visible rather than reconciled — the only way to make them agree would be to change one of the two tables, and this site does not correct a standard. The practical reading is that a max and c max are not a single envelope over the five forms, which is also why this page does not present them as one. As elsewhere in the family: the letters a and c carry no written definition in any reproduction we can check, no mass is tabulated and none is calculated, and the shank shape is explicitly left to the manufacturer. The commercial length series is 80 to 3200 mm.