DINanchor-bolts

DIN 529 C Anchor Bolt, Form C

Form C shares its head width with form E and its g column with forms A and F, which is why the standard prints those three forms as one table with shared rows. What makes it different is the c column: C runs 12 mm at M8 to 110 mm at M64, an order of magnitude below form A over the same diameters. The a column stops at M48 in the 2010 table; M56 and M64 are printed as blanks here rather than copied down from M48.

Dimensioned drawing — DIN 529 C M30head not drawn — see a and c in the table⌀d 30b 75
DIN 529 C M30 — Anchor boltNominal dimensions in mm · Not to scale

Where it is used

Form C is the one to look at when the head has to stay small: over the same diameters its c values run an order of magnitude below form A's, from 12 mm at M8 to 110 mm at M64, while its g values are the smallest of the five forms. The standard prints forms C and E together for the a column, so the two share a head width at every diameter and differ in c and g. Mechanically it is the same kind of fixing as form A — head buried in the masonry, nut on the free thread — and the same caveat applies: the standard states no pull-out resistance, because that comes from what the bolt is embedded in.

How to choose it

Pick the form on the pocket the masonry can take, not on the thread: a and c are what have to fit the hole or slot that is cut for the head, and the smaller head of form C is the reason to choose it where the pocket is shallow. The a column stops at M48 in the 2010 table, so for M56 and M64 this page prints a blank — the c and g values for those two sizes are still tabulated and are still shown. Thread and length follow the other forms: the thread has to take the nut and washer, and the length is plate thickness plus embedment, neither of which this standard states.

Dimensions12 sizes · millimetres

Thread dPitch P (mm)Thread length b (mm)a (mm)c (mm)g (mm)
M81.252016125
M101.52520157
M121.753024188
M16240322411
M202.550403014
M24360483618
M303.575604524
M36490725430
M424.5105856334
M485120987240
M565.5140—8445
M646160—9650

Nominal dimensions in millimetres as published in DIN 529 C. Tolerances, material requirements and marking are defined separately by the issuing body.

Available sizeslinked to individual specification pages

Thread referencesused by the sizes above

Fitting and interchange notes

The a column of form C ends at M48 in the 2010 edition and the blank cells at M56 and M64 are printed as blanks here; the neighbouring a values are not copied down. Its c and g columns do run to M64. Two conventions from the family matter when comparing this page with a catalogue: the letters a, c and g are the standard's own and no reproduction this site can check defines them in words, and the head is therefore drawn neither here nor on any page of this family. There is no mass table, and no mass is calculated, because the shank the volume would depend on is the part the standard leaves to the manufacturer. The commercial lengths run 80 to 3200 mm and are not the subject of pages of their own. M72x6 is in the standard's table but not in this database, whose ISO 261 coarse records stop at M64.