DIN 529 E M24 Anchor bolt
DIN 529 E M24 is an anchor bolt, on a M24 × 3 mm metric thread. Form E has no g column in the 2010 table, and its a and c columns stop at M48, so this page runs to M48 while forms A and B run to M64. Two of its c values are larger than the c max printed in the same edition — M24 and M42 — and both are recorded on this page rather than smoothed over: a reader comparing the two tables of one standard deserves to see the two cells where they disagree.
Dimensions
Nominal values in millimetres as published in DIN 529 E. Columns b, a and c are printed under the letters DIN 529 gives them: the 2010 edition carries no legend that defines them in words, so this page does not supply one. The DIN 529 E table prints no mass for any size, and none is calculated here either: the standard leaves the shape of the shank to the manufacturer, so the volume is not fixed by the dimensions it does print.
Thread data
Full M24 thread pageOther lengthsDIN 529 E M24
All M24 specificationsChoosing and fitting this size
DIN 529 E M24 is an anchor bolt in M24, on a 3 mm coarse pitch. The nut is a separate purchase: DIN 529 covers the bolt, and it is used with a hexagon nut of the same thread. What holds it is not the nut but the embedded end — the bolt is set into masonry or concrete, and the standard states that resistance to stripping is not specified, because it depends on the material the bolt is embedded in. The hole and the depth of embedment are therefore not given by this standard.
DIN 529 assigns no property class. The table fixes the thread, the thread length and the head envelope, and the strength comes from the steel the bolt is made from rather than from a marking on it. The standard also states that resistance to stripping is not specified, because it depends on the material the bolt is embedded in — so a higher class of steel does not by itself make a stronger fixing. In a weak substrate the bolt comes out with a cone of material around it, and that happens well below the tensile strength of the steel.
For a tapped hole, M24 × 3 mm takes a 21 mm tap drill, and the external thread's minor diameter is 20.32 mm — that is the section carrying the load, not the nominal M24 figure. Thread engagement of at least one times the nominal diameter is what lets the bolt fail before the thread strips.