DIN 571 Hexagon Head Wood Screw
A hexagon head screw with a coarse wood thread and a tapered point, driven into timber without a nut. The head takes a spanner, so it can be pulled down far harder than a slotted wood screw, which is why this is the pattern used for structural timber connections — pergolas, deck framing, sleeper walls and the like. It is not a bolt: there is no machine thread and nothing to thread a nut onto. Nominal diameters run from 4 to 20 mm and the standard prints a mass for every length it makes, so the length lists on these pages differ from diameter to diameter rather than running as one block.
Where it is used
DIN 571 is the hexagon head wood screw: a coarse wood thread, a tapered point and a hexagon that takes a spanner. It is driven straight into timber — no nut, no pre-tapped hole — so it belongs to carpentry and timber framing rather than to machine assembly. The hexagon is the whole point of the pattern: a spanner puts far more torque into the head than a screwdriver slot can take, which is why this is the screw used where a joint has to be pulled down hard — pergolas, deck framing, sleeper walls, battens over rafters. It is not a bolt: the thread is the coarse DIN 7998 wood thread, and nothing in this database pairs a nut with it.
How to choose it
Choose the diameter from the thickness of the piece being fixed and from the load, then choose the length so that the threaded part passes through that piece and bites well into the piece behind it. What the standard does not give is a strength class — a wood screw has no property class the way a bolt has 8.8, so its capacity comes from the timber design rules, not from this table. Whether the timber needs a pilot hole depends on species, moisture content and diameter; the standard says nothing about it, and this database does not invent a hole size for it. The mass column is the standard's own approximate figure at 7.85 kg/dm³, which is what makes the weight of a box of screws a table lookup rather than a calculation.
Dimensions9 sizes · millimetres
| Thread d (mm) | Shank diameter ds max. (mm) | Width across flats s (mm) | Width across corners e min. (mm) | Head height k (mm) |
|---|---|---|---|---|
| 4 | 4 | 7 | 7.5 | 2.8 |
| 5 | 5 | 8 | 8.63 | 3.5 |
| 6 | 6 | 10 | 10.89 | 4 |
| 7 | 7 | 12 | 13.07 | 5 |
| 8 | 8 | 13 | 14.2 | 5.5 |
| 10 | 10 | 17 | 18.72 | 7 |
| 12 | 12 | 19 | 20.88 | 8 |
| 16 | 16 | 24 | 26.17 | 10 |
| 20 | 20 | 30 | 32.95 | 13 |
Nominal dimensions in millimetres as published in DIN 571. Tolerances, material requirements and marking are defined separately by the issuing body.
Available sizeslinked to individual specification pages
Fitting and interchange notes
The lengths listed for each diameter are the lengths the standard prints an approximate mass for — that is, the combinations that exist as commercial items — so they are neither continuous nor the same from one diameter to the next. A diameter that appears in the dimension table but carries no mass entry has no sizes published here at all: the table still defines its head and shank, but there is no length to list, and this database will not fill the gap with an interpolation. The nominal diameter printed on these pages is the outside diameter of the thread, which is also the maximum shank diameter — it is not a machine thread size and carries no metric pitch.