DIN 571 20 × 180 Hexagon head
DIN 571 20 × 180 is a hexagon head wood screw with a 180 mm nominal length, 20 mm wood thread. A hexagon head screw with a coarse wood thread and a tapered point, driven into timber without a nut. The head takes a spanner, so it can be pulled down far harder than a slotted wood screw, which is why this is the pattern used for structural timber connections — pergolas, deck framing, sleeper walls and the like. It is not a bolt: there is no machine thread and nothing to thread a nut onto. Nominal diameters run from 4 to 20 mm and the standard prints a mass for every length it makes, so the length lists on these pages differ from diameter to diameter rather than running as one block.
Dimensions
- Standard
- DIN 571
- Type
- Hexagon head wood screw
- Size
- 20 × 180
- Diameter
- 20
- Length L
- 180 mm
- Shank diameter ds max.
- 20 mm
- Width across flats s
- 30 mm
- Width across corners e min.
- 32.95 mm
- Head height k
- 13 mm
- Drive
- External hexagon
- Head
- Hexagon head
Nominal values in millimetres as published in DIN 571. Mass 385 g per piece in steel (387.45 g in stainless), taken from the DIN 571 table — kilograms per 1,000 pieces at 7.85 kg/dm³.
Other lengthsDIN 571 20
All wood-screw diametersChoosing and fitting this size
DIN 571 20 × 180 is a hexagon head with a 20 mm wood thread, 180 mm long from the bearing face of the head to the point. There is no mating nut: the thread cuts its own way into the timber, and the wood it displaces is what holds it. Whether a pilot hole is needed is decided by the species and the moisture content, not by this standard — dense hardwoods split without one, softwoods usually do not. The core diameter, not the 20 mm outside diameter, is what the pilot hole has to clear.
Wood screws are supplied in steel at 4.6 or 8.8 and in A2 or A4 stainless — 10.9 and 12.9 are not stock grades for this form. The class describes the wire rather than a clamping force: nothing here is preloaded, so what it buys you is torque resistance while driving. A 4.6 screw shears its head off in dense hardwood at a torque an 8.8 screw takes without complaint, which is the failure that actually happens in practice.