DIN 439 Hexagon Thin Nut (Jam Nut)
A low profile hex nut used as a lock nut against a full nut, or where axial space is tight. Because it carries fewer threads it is not rated for full service load on its own.
Where it is used
DIN 439 is the thin hexagon nut, also called a jam nut or lock nut. Its typical use is paired with a full nut as a locknut arrangement, or in positions where axial space will not take a full-height nut.
How to choose it
A thin nut has few engaged threads and will strip more readily under overload or repeated use, so it should not carry the primary load. In a two-nut arrangement the thin nut goes on the outside; the reverse is sometimes recommended, but from a load path standpoint it is more sound for the full nut to take the main load and the thin nut to lock it.
Dimensions12 sizes · millimetres
| Thread d | Pitch P (mm) | Width across flats s (mm) | Nut height m (mm) |
|---|---|---|---|
| M4 | 0.7 | 7 | 2.2 |
| M5 | 0.8 | 8 | 2.7 |
| M6 | 1 | 10 | 3.2 |
| M8 | 1.25 | 13 | 4 |
| M10 | 1.5 | 16 | 5 |
| M12 | 1.75 | 18 | 6 |
| M14 | 2 | 21 | 7 |
| M16 | 2 | 24 | 8 |
| M18 | 2.5 | 27 | 9 |
| M20 | 2.5 | 30 | 10 |
| M22 | 2.5 | 34 | 11 |
| M24 | 3 | 36 | 12 |
Nominal dimensions in millimetres as published in DIN 439. Tolerances, material requirements and marking are defined separately by the issuing body.
Available sizeslinked to individual specification pages
Thread referencesused by the sizes above
Fitting and interchange notes
Dimensionally interchangeable with ISO 4035. Height is about 0.5 times nominal diameter, and in vibration duty a two-nut arrangement locks less well than a nylon insert nut or thread adhesive — on critical joints switch to DIN 985.