ISOnuts
ISO 4035 Hexagon Thin Nut, Chamfered
ISO version of the low hex nut, chamfered on both faces.
Where it is used
ISO 4035 is the chamfered thin hexagon nut, corresponding to DIN 439, chamfered at both ends and used for locking and space-restricted positions.
How to choose it
Property classes normally stop at 04 and 05, far below a full-height nut, which reflects the load limitation of a thin nut. Do not expect full-nut performance from it when selecting.
Dimensions12 sizes · millimetres
| Thread d | Pitch P (mm) | Width across flats s (mm) | Nut height m (mm) |
|---|---|---|---|
| M4 | 0.7 | 7 | 2.2 |
| M5 | 0.8 | 8 | 2.7 |
| M6 | 1 | 10 | 3.2 |
| M8 | 1.25 | 13 | 4 |
| M10 | 1.5 | 16 | 5 |
| M12 | 1.75 | 18 | 6 |
| M14 | 2 | 21 | 7 |
| M16 | 2 | 24 | 8 |
| M18 | 2.5 | 27 | 9 |
| M20 | 2.5 | 30 | 10 |
| M22 | 2.5 | 34 | 11 |
| M24 | 3 | 36 | 12 |
Nominal dimensions in millimetres as published in ISO 4035. Tolerances, material requirements and marking are defined separately by the issuing body.
Available sizeslinked to individual specification pages
Thread referencesused by the sizes above
Fitting and interchange notes
Interchangeable with DIN 439. Note that ISO 4035 also exists in a metric fine thread version, and a fine thread thin nut will not run on a coarse thread bolt — check the pitch when buying.