DIN 985 Prevailing Torque Hexagon Nut with Nylon Insert
A full hex nut with a nylon collar that grips the thread and resists vibration loosening. Note that the nylon insert has a temperature limit — above roughly 120 °C it loses its locking effect.
Where it is used
DIN 985 is the nylon insert lock nut. The insert is compressed by the thread as it is run on, and the resulting friction resists loosening. It is used in vibrating service such as fans, pumps, vehicle chassis and industrial machinery.
How to choose it
The nylon insert is good to about 120 °C, above which it softens and loses function, so high-temperature applications need an all-metal lock nut. Reuse is limited — about five cycles is the usual guidance, since the prevailing torque drops each time. Common classes are 8 and 10, with A2 and A4 in stainless.
Dimensions12 sizes · millimetres
| Thread d | Pitch P (mm) | Width across flats s (mm) | Nut height m (mm) | Overall height h (max) (mm) |
|---|---|---|---|---|
| M3 | 0.5 | 5.5 | 4 | 4.5 |
| M4 | 0.7 | 7 | 5 | 6 |
| M5 | 0.8 | 8 | 6 | 6.8 |
| M6 | 1 | 10 | 7.5 | 8 |
| M8 | 1.25 | 13 | 9.5 | 9.9 |
| M10 | 1.5 | 16 | 12.5 | 12.8 |
| M12 | 1.75 | 18 | 15 | 16 |
| M14 | 2 | 21 | 17 | 18.5 |
| M16 | 2 | 24 | 19 | 20.5 |
| M18 | 2.5 | 27 | 21 | 23 |
| M20 | 2.5 | 30 | 22 | 25 |
| M24 | 3 | 36 | 26 | 29 |
Nominal dimensions in millimetres as published in DIN 985. Tolerances, material requirements and marking are defined separately by the issuing body.
Available sizeslinked to individual specification pages
Thread referencesused by the sizes above
Fitting and interchange notes
Dimensionally interchangeable with ISO 10511. Because the insert occupies part of the height the overall height is greater than DIN 934, so allow more wrench clearance. Fit it chamfer-end first — that is the side the insert sits on.