ISO 10511 Prevailing Torque Hexagon Nut with Non-Metallic Insert
ISO equivalent of DIN 985. Reuse is limited — the prevailing torque drops each time the insert is run over the thread.
Where it is used
ISO 10511 is the prevailing torque nut with a non-metallic insert, corresponding to DIN 985, and is one of the most common anti-loosening solutions in vibrating service.
How to choose it
Property classes span 5, 8, 10 and 12, and selection follows the same rule of matching the bolt class. The insert is normally polyamide, which stiffens and increases prevailing torque at low temperature — confirm the service temperature range with the supplier for very cold applications.
Dimensions12 sizes · millimetres
| Thread d | Pitch P (mm) | Width across flats s (mm) | Nut height m (mm) | Overall height h (max) (mm) |
|---|---|---|---|---|
| M3 | 0.5 | 5.5 | 4 | 4.5 |
| M4 | 0.7 | 7 | 5 | 6 |
| M5 | 0.8 | 8 | 6 | 6.8 |
| M6 | 1 | 10 | 7.5 | 8 |
| M8 | 1.25 | 13 | 9.5 | 9.9 |
| M10 | 1.5 | 16 | 12.5 | 12.8 |
| M12 | 1.75 | 18 | 15 | 16 |
| M14 | 2 | 21 | 17 | 18.5 |
| M16 | 2 | 24 | 19 | 20.5 |
| M18 | 2.5 | 27 | 21 | 23 |
| M20 | 2.5 | 30 | 22 | 25 |
| M24 | 3 | 36 | 26 | 29 |
Nominal dimensions in millimetres as published in ISO 10511. Tolerances, material requirements and marking are defined separately by the issuing body.
Available sizeslinked to individual specification pages
Thread referencesused by the sizes above
Fitting and interchange notes
Interchangeable with DIN 985. ISO 10511 specifies the insert properties and test methods in more detail, including the torque required on first run-on and on the fifth removal, which is the basis for the usual guidance on reuse.