DIN 7981 ST3.5 × 16 Cross recessed pan head
DIN 7981 ST3.5 × 16 is a cross recessed pan head tapping screw with a 16 mm nominal length, a ST3.5 self-tapping thread. A pan head screw with a cross recess and a thread that cuts its own way into sheet metal, plastic or softwood — there is no nut and no pre-cut thread. The head is the reason to pick it over a countersunk tapping screw: its bearing face is flat and sits on top of the panel, spreading the clamp load instead of wedging into the hole, which is what you want on thin sheet and on anything that will be taken apart again. Nominal sizes run ST2.2 to ST6.3, and the standard prints a mass for every commercial size, so the length lists differ from diameter to diameter rather than running as one block. Two readings of the table catch people out: the head height is a tolerance band (k max and k min), and ST3.9 is a size in its own right, not a variant of ST3.5 — its pitch is 1.4 where ST3.5 is 1.3.
Dimensions
- Standard
- DIN 7981
- Type
- Cross recessed pan head tapping screw
- Size
- ST3.5 × 16
- Thread size
- ST3.5
- Length L
- 16 mm
- Pitch P
- 1.3 mm
- Head diameter dk max.
- 6.9 mm
- Head diameter dk min.
- 6.54 mm
- Head height k max.
- 2.6 mm
- Head height k min.
- 2.35 mm
- Cross recess no.
- 2 mm
- Type H m ref.
- 4.2 mm
- Drive
- Cross recess (H)
- Head
- Cross recessed pan head
Nominal values in millimetres as published in DIN 7981. Mass 1.17 g per piece in steel (1.18 g in stainless), taken from the DIN 7981 table — kilograms per 1,000 pieces at 7.85 kg/dm³.
Other lengthsDIN 7981 ST3.5
All self-tapping-screw diametersChoosing and fitting this size
DIN 7981 ST3.5 × 16 is a cross recessed pan head with a ST3.5 self-tapping thread, 16 mm long under the head. There is no mating nut and no pre-cut thread: the screw cuts its own thread in the panel and is held by the material it displaced. The hole to drill is not given by this standard — it depends on the panel material and its thickness — so the ST3.5 on this page is the screw's thread, not the hole.
Tapping screws carry no property class, and this standard does not assign one: the mechanical properties are governed by the wire document (ISO 2702 for steel), not by a marking on the head. What matters instead is surface hardness — the point and the first threads have to be harder than the panel they cut — together with a core tough enough not to snap under the driver. That is why the stainless versions are not a drop-in substitute: A2 and A4 cannot be surface-hardened the same way, so they cut more slowly and are the wrong choice for hard sheet even where they are the right choice for corrosion.