DIN 7982Cross recessed countersunk headCross recess (H)

DIN 7982 ST5.5 × 50 Cross recessed countersunk head

DIN 7982 ST5.5 × 50 is a cross recessed countersunk head tapping screw with a 50 mm nominal length, a ST5.5 self-tapping thread. The countersunk version of DIN 7981: same self-tapping thread, same cross recess, but the head is a cone so that it finishes flush with the panel. That is what makes it the screw for anything that has to slide over the joint — hinges, drawer runners, sheet-metal covers, floor plates — and it is also what limits it, because a countersunk head centres itself in the hole and pulls the panel down as it seats, so it will dimple thin sheet if the hole is not countersunk to match. Nominal sizes run ST2.2 to ST6.3. Note what the table does not give: the head height is a single approximate value rather than a tolerance band, and there is no head angle column, so the countersink angle has to come from the mating part rather than from this standard.

Dimensioned drawing — DIN 7982 ST5.5 × 50⌀dk 10.8k 3.4cross recess H3⌀d 5.5l 50
DIN 7982 ST5.5 × 50 — Cross recessed countersunk headNominal dimensions in mm · Not to scale
ThreadST5.5
Length50 mm
HeadCross recessed countersunk head
DriveCross recess (H)

Dimensions

Standard
DIN 7982
Type
Cross recessed countersunk head tapping screw
Size
ST5.5 × 50
Thread size
ST5.5
Length L
50 mm
Pitch P
1.8 mm
Head diameter dk max.
10.8 mm
Head diameter dk min.
10.37 mm
Head depth k approx.
3.4 mm
Cross recess no.
3 mm
Type H m ref.
6.8 mm
Drive
Cross recess (H)
Head
Cross recessed countersunk head

Nominal values in millimetres as published in DIN 7982. Mass 6.9 g per piece in steel (6.94 g in stainless), taken from the DIN 7982 table — kilograms per 1,000 pieces at 7.85 kg/dm³.

Other lengthsDIN 7982 ST5.5

All self-tapping-screw diameters

Choosing and fitting this size

DIN 7982 ST5.5 × 50 is a cross recessed countersunk head with a ST5.5 self-tapping thread, 50 mm long overall, measured from the top face of the head. There is no mating nut and no pre-cut thread: the screw cuts its own thread in the panel and is held by the material it displaced. The hole to drill is not given by this standard — it depends on the panel material and its thickness — so the ST5.5 on this page is the screw's thread, not the hole.

Tapping screws carry no property class, and this standard does not assign one: the mechanical properties are governed by the wire document (ISO 2702 for steel), not by a marking on the head. What matters instead is surface hardness — the point and the first threads have to be harder than the panel they cut — together with a core tough enough not to snap under the driver. That is why the stainless versions are not a drop-in substitute: A2 and A4 cannot be surface-hardened the same way, so they cut more slowly and are the wrong choice for hard sheet even where they are the right choice for corrosion.