DIN 96 2.5 × 14 Slotted round head
DIN 96 2.5 × 14 is a slotted round head wood screw with a 14 mm nominal length, 2.5 mm wood thread. The plain wood screw most people mean by the word: a round head with a single slot, a coarse wood thread and a tapered point, turned in with a flat-blade screwdriver. It is the pattern behind almost every hinge, catch, bracket and drawer runner fixed into timber, because the round head sits proud of the surface and spreads its load over a small washer-like face instead of digging in. The slot is why it is not a structural fastener: a driver can only apply as much torque as the slot will take before it cams out, which on the smaller sizes is very little. Nominal diameters run from 1.6 to 8 mm. Two things about the table are worth knowing before reading it: the 1.6 and 5.5 mm columns come from the 2016 edition of the dimension table (the second source consulted prints 2 to 8 mm, identical on every one of those ten diameters), and the mass table marks several diameters as commercial sizes with the letter X instead of a mass — a size that is made, but whose weight the standard does not print.
Dimensions
- Standard
- DIN 96
- Type
- Slotted round head wood screw
- Size
- 2.5 × 14
- Diameter
- 2.5
- Length L
- 14 mm
- Head diameter dk
- 5 mm
- Head height k
- 1.7 mm
- Slot width n
- 0.6 mm
- Slot depth t max.
- 1.1 mm
- Slot depth t min.
- 0.85 mm
- Drive
- Slotted
- Head
- Slotted round head
Nominal values in millimetres as published in DIN 96. Mass 0.581 g per piece in steel (0.58 g in stainless), taken from the DIN 96 table — kilograms per 1,000 pieces at 7.85 kg/dm³.
Other lengthsDIN 96 2.5
All wood-screw diametersChoosing and fitting this size
DIN 96 2.5 × 14 is a slotted round head with a 2.5 mm wood thread, 14 mm long from the bearing face of the head to the point. There is no mating nut: the thread cuts its own way into the timber, and the wood it displaces is what holds it. Whether a pilot hole is needed is decided by the species and the moisture content, not by this standard — dense hardwoods split without one, softwoods usually do not. The core diameter, not the 2.5 mm outside diameter, is what the pilot hole has to clear.
Wood screws are supplied in steel at 4.6 or 8.8 and in A2 or A4 stainless — 10.9 and 12.9 are not stock grades for this form. The class describes the wire rather than a clamping force: nothing here is preloaded, so what it buys you is torque resistance while driving. A 4.6 screw shears its head off in dense hardwood at a torque an 8.8 screw takes without complaint, which is the failure that actually happens in practice.