DIN 97 6 × 50 Slotted countersunk head
DIN 97 6 × 50 is a slotted countersunk head wood screw with a 50 mm nominal length, 6 mm wood thread. The same wood screw as DIN 96 with the head turned into a cone, so that it finishes flush with the timber instead of standing proud of it. That single change is why this is the pattern for floorboards, decking, stair treads and anything that has to be walked on or slid over: nothing catches on the head. It pays for that in holding power, because a countersunk head bears on the cone rather than on a flat face, and in timber it will pull itself into the wood until the cone bottoms out — which is why the countersink, not the screw, decides how deep it sits. Nominal diameters run from 1.6 to 10 mm. Note what the table does not give: there is no head angle column and no mass for several diameters, which the standard marks X as commercial sizes.
Dimensions
- Standard
- DIN 97
- Type
- Slotted countersunk head wood screw
- Size
- 6 × 50
- Diameter
- 6
- Length L
- 50 mm
- Head diameter D
- 11 mm
- Head depth k max.
- 3 mm
- Slot width n
- 1.6 mm
- Slot depth t max.
- 1.6 mm
- Slot depth t min.
- 1.2 mm
- Drive
- Slotted
- Head
- Slotted countersunk head
Nominal values in millimetres as published in DIN 97. Mass 9.12 g per piece in steel (9.18 g in stainless), taken from the DIN 97 table — kilograms per 1,000 pieces at 7.85 kg/dm³.
Other lengthsDIN 97 6
All wood-screw diametersChoosing and fitting this size
DIN 97 6 × 50 is a slotted countersunk head with a 6 mm wood thread, 50 mm long from the bearing face of the head to the point. There is no mating nut: the thread cuts its own way into the timber, and the wood it displaces is what holds it. Whether a pilot hole is needed is decided by the species and the moisture content, not by this standard — dense hardwoods split without one, softwoods usually do not. The core diameter, not the 6 mm outside diameter, is what the pilot hole has to clear.
Wood screws are supplied in steel at 4.6 or 8.8 and in A2 or A4 stainless — 10.9 and 12.9 are not stock grades for this form. The class describes the wire rather than a clamping force: nothing here is preloaded, so what it buys you is torque resistance while driving. A 4.6 screw shears its head off in dense hardwood at a torque an 8.8 screw takes without complaint, which is the failure that actually happens in practice.