DINscrewsCountersunk head (90°)

DIN 7991 Hexagon Socket Countersunk Head Screw

Flat head version of the socket screw. The 90° cone seats flush in a matching countersink so nothing protrudes above the surface.

Dimensioned drawing — DIN 7991 M10 × 20k 6.2L 20⌀20⌀10
DIN 7991 M10 × 20 — Countersunk head (90°)Nominal dimensions in mm · Not to scale

Where it is used

DIN 7991 is the countersunk socket head screw. The 90° cone seats in the countersink so the head finishes flush, which is what makes it the choice wherever a protruding head is impossible — sliding ways, mould parting faces, and surfaces that will be covered by a trim panel.

How to choose it

Because the head itself does part of the locating, the accuracy of the 90° countersink drives assembly quality: an off-angle countersink leaves the head in line contact with the wall and concentrates stress locally. Common classes are 8.8 and 10.9, with 12.9 scarce in countersunk sizes. Below M3 the head diameter is large relative to the thread, so on thin plate check the remaining wall thickness.

Dimensions11 sizes · millimetres

Thread dPitch P (mm)Head diameter dk (mm)Head height k (mm)Socket size s (mm)Thread length b (min) (mm)
M30.561.86218
M40.782.482.520
M50.8103.1322
M61123.72424
M81.25164.96528
M101.5206.2632
M121.75247.44836
M142278.41040
M162308.81244
M182.53310.21448
M202.536111452

Nominal dimensions in millimetres as published in DIN 7991. Tolerances, material requirements and marking are defined separately by the issuing body.

Available sizeslinked to individual specification pages

Thread referencesused by the sizes above

Fitting and interchange notes

The 90° angle matches ISO 10642, so one countersink takes either screw, and the nominal head diameter is the same at every size here — which is why the comparison page for this pair reports no dimensional difference. What the two standards do not say the same way is how far below that nominal the head may measure: DIN 7991 gives dk a maximum and a minimum, while ISO 10642 states a theoretical maximum at the sharp corner of the 90° cone plus a minimum measured on the head as actually made, where that corner is cut away by the top face. The nominal figure agrees; the floor beneath it does not, and a head at the ISO minimum presents a smaller bearing circle in a countersink cut to the DIN drawing. Worth checking in precision work.

Specified in these projectsbuilds that call for this standard by name

All projects