DINscrewsHeadless

DIN 915 Hexagon Socket Set Screw — Dog Point

A cylindrical dog point that drops into a drilled hole in the shaft. It locks the position without damaging the shaft surface.

Dimensioned drawing — DIN 915 M8 × 8L 8⌀4⌀8
DIN 915 M8 × 8 — HeadlessNominal dimensions in mm · Not to scale

Where it is used

DIN 915 is the dog point socket set screw, with a flat face and a short cylindrical pin at the end. The pin enters a drilled hole in the shaft to locate like a small dowel while the flat face bears on the hole bottom.

How to choose it

A dog point gives some locating ability without the strict alignment a cone demands, which suits joints that need locking but minimum shaft damage. The pin diameter is smaller than the thread minor diameter, so check the hole size in the shaft when selecting.

Dimensions8 sizes · millimetres

Thread dPitch P (mm)Socket size s (mm)
M30.51.5
M40.72
M50.82.5
M613
M81.254
M101.55
M121.756
M1628

Nominal dimensions in millimetres as published in DIN 915. Tolerances, material requirements and marking are defined separately by the issuing body.

Available sizeslinked to individual specification pages

Thread referencesused by the sizes above

Fitting and interchange notes

Dimensionally interchangeable with ISO 4028. Of the three common set screw types the dog point damages the shaft least, making it the better choice for collars whose position is adjusted frequently.