DIN 914 Hexagon Socket Set Screw — Cone Point
A conical point that seats into a mating centre hole. It gives positive location rather than just friction, so the part can be removed and refitted in exactly the same place.
Where it is used
DIN 914 is the cone point socket set screw, ending in a 120° cone. The cone can seat into a pre-drilled cone in the shaft to locate and fix at once, which suits assemblies that are taken apart and must return to the same position.
How to choose it
The cone point must be used with a matching cone in the shaft: without one the contact patch is tiny, it slips easily and it damages the shaft. The advantage is that the damage is confined to the drilled cone rather than the ring-shaped scar a cup point leaves.
Dimensions8 sizes · millimetres
| Thread d | Pitch P (mm) | Socket size s (mm) |
|---|---|---|
| M3 | 0.5 | 1.5 |
| M4 | 0.7 | 2 |
| M5 | 0.8 | 2.5 |
| M6 | 1 | 3 |
| M8 | 1.25 | 4 |
| M10 | 1.5 | 5 |
| M12 | 1.75 | 6 |
| M16 | 2 | 8 |
Nominal dimensions in millimetres as published in DIN 914. Tolerances, material requirements and marking are defined separately by the issuing body.
Available sizeslinked to individual specification pages
Thread referencesused by the sizes above
Fitting and interchange notes
Dimensionally interchangeable with ISO 4027. Because a cone must be drilled first, the installation has one more step than a cup point and is rarely first choice in high-volume assembly. It suits jigs and fixtures needing repeatable precise location.