DIN 912 Hexagon Socket Head Cap Screw
A cap screw with a cylindrical head and internal hex drive. Because the head sits above the surface and the drive is recessed, it can be tightened hard and used in counterbores for a flush finish.
Where it is used
DIN 912 is the socket head cap screw found throughout machine tools, moulds, jigs and automation equipment. Because the hex key enters the head axially it needs almost no radial clearance, which makes it far easier to arrange in dense hole patterns than an external hexagon bolt. The cylindrical head can be sunk into a counterbore for a flush finish, or left proud where appearance is not critical.
How to choose it
The standard stock classes are 8.8, 10.9 and 12.9. Class 12.9 is the usual choice where fatigue and high preload matter, but it is susceptible to hydrogen embrittlement, so electroplated parts must be baked to the specified schedule afterwards. Stainless equivalents are normally A2-70 and A4-80, with A4 for marine or chemical service. One practical note: sizes below M3 are difficult to cold form, so the market is dominated by class 10.9 while 8.8 is unusual.
Dimensions15 sizes · millimetres
| Thread d | Pitch P (mm) | Head diameter dk (mm) | Head height k (mm) | Socket size s (mm) | Thread length b (min) (mm) |
|---|---|---|---|---|---|
| M2 | 0.4 | 3.8 | 2 | 1.5 | 16 |
| M2.5 | 0.45 | 4.5 | 2.5 | 2 | 17 |
| M3 | 0.5 | 5.5 | 3 | 2.5 | 18 |
| M4 | 0.7 | 7 | 4 | 3 | 20 |
| M5 | 0.8 | 8.5 | 5 | 4 | 22 |
| M6 | 1 | 10 | 6 | 5 | 24 |
| M8 | 1.25 | 13 | 8 | 6 | 28 |
| M10 | 1.5 | 16 | 10 | 8 | 32 |
| M12 | 1.75 | 18 | 12 | 10 | 36 |
| M14 | 2 | 21 | 14 | 12 | 40 |
| M16 | 2 | 24 | 16 | 14 | 44 |
| M18 | 2.5 | 27 | 18 | 14 | 48 |
| M20 | 2.5 | 30 | 20 | 17 | 52 |
| M22 | 2.5 | 33 | 22 | 17 | 56 |
| M24 | 3 | 36 | 24 | 19 | 60 |
Nominal dimensions in millimetres as published in DIN 912. Tolerances, material requirements and marking are defined separately by the issuing body.
Available sizeslinked to individual specification pages
Thread referencesused by the sizes above
Fitting and interchange notes
Dimensionally interchangeable with ISO 4762, so the two can be mixed in the same assembly. The differences are in thread tolerance and marking requirements — both call up 6g thread, which is why interchange does not affect fit. Torque to a preload of roughly 0.8 to 1.0 times the nominal diameter; on class 12.9 use a torque wrench rather than feel.