DIN 85 Slotted Pan Head Screw
A slightly domed head with straight slot drive. Larger bearing face than a cheese head, useful on thin sheet.
Where it is used
DIN 85 is the slotted pan head screw, with a rounded top and flat bearing face. Compared with a cheese head it offers a larger bearing area, so it is less likely to crush thin sheet or soft material.
How to choose it
Head height is a little greater than a cheese head and the appearance softer, which makes it the better choice on visible surfaces. Common grades are 4.8 and A2 stainless.
Dimensions9 sizes · millimetres
| Thread d | Pitch P (mm) | Head diameter dk (mm) | Head height k (mm) |
|---|---|---|---|
| M2 | 0.4 | 4 | 1.3 |
| M2.5 | 0.45 | 5 | 1.5 |
| M3 | 0.5 | 5.6 | 1.8 |
| M3.5 | 0.6 | 7 | 2.1 |
| M4 | 0.7 | 8 | 2.4 |
| M5 | 0.8 | 9.5 | 3 |
| M6 | 1 | 12 | 3.6 |
| M8 | 1.25 | 16 | 4.8 |
| M10 | 1.5 | 20 | 6 |
Nominal dimensions in millimetres as published in DIN 85. Tolerances, material requirements and marking are defined separately by the issuing body.
Available sizeslinked to individual specification pages
Thread referencesused by the sizes above
Fitting and interchange notes
Dimensionally interchangeable with ISO 1580. The domed head limits slot depth, so the risk of cam-out is the same; keep the screwdriver in line with the screw axis during assembly.