DIN 529 AAnchor bolt

DIN 529 A M48 Anchor bolt

DIN 529 A M48 is an anchor bolt, on a M48 × 5 mm metric thread. A foundation bolt for embedding in masonry or concrete: a forged head that keys into the material, a plain shank, and a metric thread at the free end for a hexagon nut. Form A is the straight-shank variant. DIN 529 fixes the thread, the thread length b, the head columns a and c, and a series of commercial lengths from 80 to 3200 mm — and it explicitly leaves the shape of the shank to the manufacturer, so two compliant bolts can differ behind the head. Nothing on this page is calculated: the table is reproduced column for column, including the columns this site does not interpret.

Dimensioned drawing — DIN 529 A M48head not drawn — see a and c in the table⌀d 48b 120
DIN 529 A M48 — Anchor boltNominal dimensions in mm · Not to scale
Diameter48 mm
Pitch5 mm
Thread length b120 mm

Dimensions

Standard
DIN 529 A
Type
Anchor bolt
Size
M48
Thread
M48 × 5
Thread length b
120 mm
a
155 mm
c
250 mm
g
180 mm

Nominal values in millimetres as published in DIN 529 A. Columns b, a, c and g are printed under the letters DIN 529 gives them: the 2010 edition carries no legend that defines them in words, so this page does not supply one. The DIN 529 A table prints no mass for any size, and none is calculated here either: the standard leaves the shape of the shank to the manufacturer, so the volume is not fixed by the dimensions it does print.

DesignationM48 × 5
Pitch5 mm
Nominal Ø48 mm
Pitch Ø44.75 mm
Minor Ø ext41.87 mm
Tap drillØ 43 mm

Other lengthsDIN 529 A M48

All M48 specifications

Choosing and fitting this size

DIN 529 A M48 is an anchor bolt in M48, on a 5 mm coarse pitch. The nut is a separate purchase: DIN 529 covers the bolt, and it is used with a hexagon nut of the same thread. What holds it is not the nut but the embedded end — the bolt is set into masonry or concrete, and the standard states that resistance to stripping is not specified, because it depends on the material the bolt is embedded in. The hole and the depth of embedment are therefore not given by this standard.

DIN 529 assigns no property class. The table fixes the thread, the thread length and the head envelope, and the strength comes from the steel the bolt is made from rather than from a marking on it. The standard also states that resistance to stripping is not specified, because it depends on the material the bolt is embedded in — so a higher class of steel does not by itself make a stronger fixing. In a weak substrate the bolt comes out with a cone of material around it, and that happens well below the tensile strength of the steel.

For a tapped hole, M48 × 5 mm takes a 43 mm tap drill, and the external thread's minor diameter is 41.87 mm — that is the section carrying the load, not the nominal M48 figure. Thread engagement of at least one times the nominal diameter is what lets the bolt fail before the thread strips.