DIN 529 FAnchor bolt

DIN 529 F M36 Anchor bolt

DIN 529 F M36 is an anchor bolt, on a M36 × 4 mm metric thread. Form F is the only one of the five with an s column, and in its row of the 2010 table g and s carry the same value at every diameter from M8 to M48 — 6, 8, 10, 14, 18, 22, 26, 30, 36, 42. Two identical columns are printed here as two columns because the standard prints two; whether that is a coincidence of the form or a duplicate in the printing is not something this page can settle. Its head width is the smallest of the five forms and its sizes stop at M48.

Dimensioned drawing — DIN 529 F M36head not drawn — see a and c in the table⌀d 36b 90
DIN 529 F M36 — Anchor boltNominal dimensions in mm · Not to scale
Diameter36 mm
Pitch4 mm
Socket size s30 mm
Thread length b90 mm

Dimensions

Standard
DIN 529 F
Type
Anchor bolt
Size
M36
Thread
M36 × 4
Thread length b
90 mm
a
55 mm
c
190 mm
g
30 mm
s
30 mm

Nominal values in millimetres as published in DIN 529 F. Columns b, a, c, g and s are printed under the letters DIN 529 gives them: the 2010 edition carries no legend that defines them in words, so this page does not supply one. The DIN 529 F table prints no mass for any size, and none is calculated here either: the standard leaves the shape of the shank to the manufacturer, so the volume is not fixed by the dimensions it does print.

DesignationM36 × 4
Pitch4 mm
Nominal Ø36 mm
Pitch Ø33.4 mm
Minor Ø ext31.09 mm
Tap drillØ 32 mm

Other lengthsDIN 529 F M36

All M36 specifications

Choosing and fitting this size

DIN 529 F M36 is an anchor bolt in M36, on a 4 mm coarse pitch. The nut is a separate purchase: DIN 529 covers the bolt, and it is used with a hexagon nut of the same thread. What holds it is not the nut but the embedded end — the bolt is set into masonry or concrete, and the standard states that resistance to stripping is not specified, because it depends on the material the bolt is embedded in. The hole and the depth of embedment are therefore not given by this standard.

DIN 529 assigns no property class. The table fixes the thread, the thread length and the head envelope, and the strength comes from the steel the bolt is made from rather than from a marking on it. The standard also states that resistance to stripping is not specified, because it depends on the material the bolt is embedded in — so a higher class of steel does not by itself make a stronger fixing. In a weak substrate the bolt comes out with a cone of material around it, and that happens well below the tensile strength of the steel.

For a tapped hole, M36 × 4 mm takes a 32 mm tap drill, and the external thread's minor diameter is 31.09 mm — that is the section carrying the load, not the nominal M36 figure. Thread engagement of at least one times the nominal diameter is what lets the bolt fail before the thread strips.