DINscrewsCountersunk head (90°)

DIN 963 Slotted Countersunk Head Screw

Slotted flat head screw for a flush finish. Note that countersunk heads pull the joint sideways, so they should not be used to locate parts.

Dimensioned drawing — DIN 963 M4 × 25k 2.2L 25⌀7.5⌀4
DIN 963 M4 × 25 — Countersunk head (90°)Nominal dimensions in mm · Not to scale

Where it is used

DIN 963 is the slotted countersunk head screw, flush once the 90° cone seats in the countersink. It is used on surfaces where a protruding head is not acceptable, such as hinges, panels and timber components.

How to choose it

Head height is entirely set by countersink depth, so the quality of that countersink decides how well the assembly turns out. Common grades are 4.8 and A2 stainless. In timber these are usually driven straight in; in metal a 90° countersink has to be cut first.

Dimensions9 sizes · millimetres

Thread dPitch P (mm)Head diameter dk (mm)Head height k (mm)
M20.43.81.2
M2.50.454.71.5
M30.55.61.65
M3.50.66.51.93
M40.77.52.2
M50.89.22.5
M61113
M81.2514.54
M101.5185

Nominal dimensions in millimetres as published in DIN 963. Tolerances, material requirements and marking are defined separately by the issuing body.

Available sizeslinked to individual specification pages

Thread referencesused by the sizes above

Fitting and interchange notes

Dimensionally interchangeable with ISO 2009, both using a 90° countersink angle. The head edge is thin, so excess tightening torque deforms the head or pulls it through — the most common failure mode for a countersunk screw.